Jan C. Aurich

TU Kaiserslautern

  • TU Kaiserslautern

SCHOLARLY PAPERS

4

DOWNLOADS

353

TOTAL CITATIONS

5

Scholarly Papers (4)

Actions:
Email selected abstracts
1.

Improving the surface morphology by adjusting the cutting parameters during cryogenic milling of Ti-6Al-4V

Proceedings of the Machining Innovations Conference for Aerospace Industry (MIC) 2021
Number of pages: 8 Posted: 01 Oct 2021 Last Revised: 17 Nov 2021
Kevin Gutzeit, Daniel Weber, Stephan Basten, Benjamin Kirsch and Jan C. Aurich
TU Kaiserslautern, TU Kaiserslautern, TU Kaiserslautern, TU Kaiserslautern and TU Kaiserslautern
Downloads 101 (528,312)
Citation 2

Abstract:

Loading...

Machining; Cryogenic milling; Ti-6Al-4V; Surface morpholog

2.

Influence of the Supplying Technique of a Sub-Zero Metalworking Fluid on the Performance of Face Turning of Ti-6Al-4V Titanium Alloy

Proceedings of the Machining Innovations Conference (MIC) 2020
Number of pages: 8 Posted: 13 Nov 2020 Last Revised: 18 Nov 2020
Stephan Basten, Benjamin Kirsch, Kevin Gutzeit, Hans Hasse and Jan C. Aurich
TU Kaiserslautern, TU Kaiserslautern, TU Kaiserslautern, TU Kaiserslautern and TU Kaiserslautern
Downloads 88 (577,131)
Citation 3

Abstract:

Loading...

cryogenic machining; cutting tool, fluid, temperature, titanium, turning, wear 1. Introduction 1.1. Machining of Ti-6Al-4V titanium alloy and supplying techniques used in turning processes The machining of Ti-6Al-4V is associated with high mechanical, thermal, and chemical loads on the cutting tool

3.

Improving the Machinability when Milling Ti-6Al-4V Using a Sub-Zero Metalworking Fluid

Proceedings of the Machining Innovations Conference for Aerospace Industry (MIC) 2023
Number of pages: 8 Posted: 22 Nov 2023
Kevin Gutzeit, Maximilian Berndt, Benjamin Kirsch and Jan C. Aurich
TU Kaiserslautern, TU Kaiserslautern, TU Kaiserslautern and TU Kaiserslautern
Downloads 82 (602,114)

Abstract:

Loading...

Ti-6Al-4V, Tool wear, sub-zero MWF, Milling, Machinability

4.

Analysis of the Effect of Cryogenic Machining on the Quality of Milled Thin-walled Monolithic Aluminum Structural Parts

Proceedings of the Machining Innovations Conference for Aerospace Industry (MIC) 2022
Number of pages: 8 Posted: 16 Nov 2022 Last Revised: 01 Feb 2023
Daniel Weber, Kevin Gutzeit, Benjamin Kirsch, Jan C. Aurich, Christopher D’Elia, Barbara S. Linke and Michael R. Hill
TU Kaiserslautern, TU Kaiserslautern, TU Kaiserslautern, TU Kaiserslautern, University of California, Davis - Department of Mechanical and Aerospace Engineering, University of California, Davis - Department of Mechanical and Aerospace Engineering and University of California, Davis - Department of Mechanical and Aerospace Engineering
Downloads 82 (602,114)

Abstract:

Loading...

cryogenic machining, residual stresses, distortion, milling aluminum