Making Monolayer Graphene Photoluminescent by Electron-Beam-Activated Fluorination Approach

Abstract

The past one and half decades have witnessed a tremendous development of graphene electronics, and the key to the success of graphene is its exceptional properties. The lacking of an inherent bandgap endows graphene with excellent electrical properties but considerably limits its applications in light-emitting and high-performance graphene-based devices. Herein, an approach for the direct writing of semiconducting and photoluminescent fluorinated graphene (C 4 F) patterns on monolayer graphene by an optimized electron-beam-activated fluorination technique is reported. A series of characterization approaches, such as atomic force microscopy, X-ray photoelectron spectroscopy and Raman spectroscopy were used to demonstrate the successful preparation of C 4 F for maskless lithography. Specially, a sharp and strong photoluminescence located at the purple light range of ~380 nm was observed in C 4 F, demonstrating a desirable semiconducting nature, and the bandgap was further confirmed by follow-up electrical measurements, where the C 4 F filed-effect transistor exhibited a p-type semiconductor behavior and significantly enhanced on/off ratio. Therefore, this work provides a novel technique for the fabrication of graphene devices for promising electronic and optoelectronic applications, but also opens a route towards the tailoring and engineering of electronic properties of graphene.

Keywords: bandgap, fluorinated graphene, monolayer graphene, photoluminescence, filed-effect transistor